Calibration
This video is a guide to calibrate by using a qualified certificate that goes with the printer.
When you find that the filaments cannot be flattened on the base plate, or the nozzle rubs against the base plate and cannot discharge, it is time to calibrate your 3D printer.
Before calibration, make sure there are no models on the base plate and no filament residues on the nozzle.
Go to Setting-Calibration-OK.
The nozzle positions. Put the card. Move the card. Feel some resistance. Save.
Watch the video below. You’ll find it out!
Further reading
Thanksgiving STEM Activities for Kids: Table Projects and Simple Engineering Challenges
Thanksgiving dinner takes hours to cook. Most kids are bored within the first one.
A bag of cranberries, a box of toothpicks, a roll of foil and a few balloons can change that. Give those supplies ...
Halloween STEM Activities for Kids: Spooky Builds That Teach Real Science
Halloween hands kids a stack of ready made science questions. Why does a pumpkin foam over? Why do ghosts melt faster with salt? How much candy can a cotton swab bridge hold?
The 16 activities belo...
STEM Crafts for Kids: Build, Decorate and Test
Pick crafts kids can test, not just finish. Build it, make it theirs, measure what it does, then change one thing and try again.
A paper helicopter takes five minutes to fold. Timing ten drops, tri...
STEM Games for Kids: Logic, Math and Building Games to Play Together
Give a seven year old a worksheet and you get ten minutes of sighing. Give the same kid 20 sticks of spaghetti, some tape and a marshmallow, then say the tallest tower wins. Different afternoon.
ST...
