Nozzle Replacement
This video is a guide to replace the 3D printer nozzle. When the nozzle cannot be cleared or is malfunctioning, it needs to be replaced. A 2.5mm hex wrench is needed.
First, unload the filament and remove the extruder tube.
Then move the nozzle to a lower position.
Turn off the printer.
Unplug the FFC.
Unscrew. Remove the old nozzle.
Change a new nozzle. Screw.
Plug in the FFC.
Insert the extruder tube.
Watch the video below. You’ll find it out!
Further reading
Thanksgiving STEM Activities for Kids: Table Projects and Simple Engineering Challenges
Thanksgiving dinner takes hours to cook. Most kids are bored within the first one.
A bag of cranberries, a box of toothpicks, a roll of foil and a few balloons can change that. Give those supplies ...
Halloween STEM Activities for Kids: Spooky Builds That Teach Real Science
Halloween hands kids a stack of ready made science questions. Why does a pumpkin foam over? Why do ghosts melt faster with salt? How much candy can a cotton swab bridge hold?
The 16 activities belo...
STEM Crafts for Kids: Build, Decorate and Test
Pick crafts kids can test, not just finish. Build it, make it theirs, measure what it does, then change one thing and try again.
A paper helicopter takes five minutes to fold. Timing ten drops, tri...
STEM Games for Kids: Logic, Math and Building Games to Play Together
Give a seven year old a worksheet and you get ten minutes of sighing. Give the same kid 20 sticks of spaghetti, some tape and a marshmallow, then say the tallest tower wins. Different afternoon.
ST...
